|
|
|
|
|
#1
02-15-2010, 07:08 AM
|
||||
|
||||
it will be easier to see a trend over a week
ie my ca test kit reads by the 20 ppm so on monday i may have 420 tuesday 420 and wednesday 400 over the week or 2 just divide the total by 7 or 14 days to give you a daily dosing amount
__________________
250G DD LED SPS R.I.P. 180G LED SPS 80"x36". 300G custom build Owner of Mountain Ridge Heating and Gas Class A gas fitter, HVAC 
|
|
#2
02-15-2010, 02:03 PM
|
||||
|
||||
|
Go
Ive done it a little different. I test (mine shows by .10), enter the values in here, under Tank Parameters), use the calculator, dose my amounts, test in 3-4 hours, this will show me if I am estimating my water volume correctly. If my levels are not where I want them, I make another adjustment. Basically, I want to get to a point where they are at (for me) 450, 9.3, 1350.
Then, I up my daily dose. by a little, according to how big a correction I had to make. It's not an exact science, but it works. Then, I keep with the dosing for a few days. Test again. If my levels are where they need to be, I keep dosing the same amount. If not, I'll make a correction dose, then up my daily dose again. I hope this helps. writing it down makes it seem complicated...but it's not. LMK. ________ Xhionella.Xxx Cam Last edited by imcosmokramer; 08-14-2011 at 07:35 AM.
|
Hybrid Mode
