|
|
|
|
|
#1
02-10-2010, 01:16 PM
|
|||||
|
|||||
In regards to ATO, I also understand the rise in ppm on the initial run off.
It will be programmed to drain off a set amount before diverting to the tank. ProfiLux has the power to do this with programmable logic control and a few solenoids. RO outlet goes to a T piece, there is a solenoid on both tee ends, one for waste pre tank fill run off and one for ATO. The run off solenoid will be programmed to come on for a few minutes prior to the tank flow solenoid coming on. Last edited by Aqua-Digital; 02-10-2010 at 01:24 PM. |
|
#2
02-10-2010, 01:30 PM
|
|||||
|
|||||
|
So equipment break down.
1 x Miracle star fire Euro braced tank 1 x BWi 5 stage RO 3 x RO electronic solenoids 1 x ProfiLux 3EX 1 x wireless bridge adapter (network is upstairs, tank downstairs so need a link to the controller) 1 x PAB power bar 1 x GHL pH probe 1 x GHL Redox probe 1 x GHL Salinity probe 1 x GHL Humidity/Air temp Probe (this is for the house) 1 x Aqua Digital ozone unit (max on two hours after feeding) 1 x 4 channel GHL slave doser 1 x BM150Pro bubble Magus Skimmer 2 x Tunze 6055 streams 2 x Tunze - GHL control cables 2 x GHL optical level sensors for ATO and AWC 2 x Aquarium Illuminations LED lighting 1 x Ai-GHL control cable 3 x Bubble Magus Balling chambers 1 x Acrylic sump 1 x Aqua Bee 2000L return pump ? x Various amounts of Lockline for the return 1 x Durso stand pipe 1 x Phos/Carbon reactor I am sure there will be more but that covers the basics. |
|
#3
02-10-2010, 01:33 PM
|
|||||
|
|||||
|
Mike, where are you getting your Reef Safe Solenoid valves from? I've been searching for a cost viable source for a long time.
__________________
Dan Pesonen Umm, a tank or 5 |
|
#4
02-10-2010, 01:35 PM
|
|||||
|
|||||
|
Auto top off dot com have done them for quite sometime these are plastic bodied, chemical resistant
|
|
#5
02-10-2010, 01:41 PM
|
|||||
|
|||||
|
Quote:
__________________
Dan Pesonen Umm, a tank or 5 |
|
#6
02-10-2010, 01:45 PM
|
|||||
|
|||||
|
the solenoids are available readily if you want to order from china, they are about $4.00 and then add shipping, so make your own.
www.alibaba.com |
|
#7
02-10-2010, 01:48 PM
|
|||||
|
|||||
|
Personally I dont think $34 is over expensive either for something pre made plug and play. You can get rid of your storage tank if you have a profiLux for under $80!
http://www.autotopoff.com/solenoid/ When you work out the cost of a storage tank - feed pump - pipework, i doubt the cost comes to much less, also take into account the fact you do not have the space issues and also only having to run 1/4" pipe. For me this method is a no brainer  Last edited by Aqua-Digital; 02-10-2010 at 01:58 PM. |
Hybrid Mode
