JBJ ATO Switch Problem

Yup it is sometimes better to get a new one but some people like to fix things and you could replace every componet one the board for less than what it costs to get a new one. YOu can buy the float switchs seporatly but if you want the controler you have to buy the whole kit. I believe it is a single layer board and putting a bit of presure on each component will not take much time its probably on the front side where the cold solder is or the corosion was. poroxide will remove the corosion on the solder. I have equipment my self but I am not driving down to summerland to pickup and deliver. I have scopes meters temp controled soldering iron most of it I would have to dig it out and unpack it. I do not have a workshop here or even a garage to work out of. Is this not what DIY is for I do have a spare DIY ATO unit I just have to make an adapter for it insted of running the controler off a computer power supply I will adapt a wall unit.

Bill