![]() |
|
#1
|
|||||
|
|||||
![]() You can save the 'wave' in both Short & Long Pulse mode by holding the Set button until the LED flashes green/white when you're done dialing it in. I can't honestly say that it will retain that setting if you switch to another mode, I'll have to try it. I run my two in Long Pulse mode (Master/Slave, anti-synch) and have saved the setting. I do know that the setting is retained if I unplug the Master. The Slave also remembers that it is in Anti-Synch after I power it down and back up again. The master shows the correct 'Salmon' colour LED when ramped up and a Green LED when at idle. I'm fairly certain the Green means the setting is saved.
I have the long pulses at about 10 seconds up to 80% power. It does not make a surface wave at that setting, but the flow in the tank alternates nicely with the two anti-synchronized.
__________________
Mike 77g sumpless SW DIY 10 watt multi-chip LED build ![]() Last edited by mike31154; 01-19-2010 at 12:42 AM. |
#2
|
||||
|
||||
![]() With my MP40W I always have to reset it when leaving the long or short pulse mode when returning to those modes
__________________
220Gal Dining room build complete! no bucket or barrel water changes!!! ![]() |
#3
|
||||
|
||||
![]() with my mp40s, I just push the set button to start the pulsing again. I think it retains the cycle, but you might have to adjust the velocity again. I run my 2 vortechs opposing each other in a 4 foot 120 and get pretty good wave action.
__________________
Last tank was 210 reef with 90 gal sump 120 , lps. 2xKessil A350W Tuna Blues, 2xvortech mp40 for flow,aqualogic 1/4 hp chiller, 160 lbs live rock. sohal, , pair of percs,flame dotty back , royal gramma, pair of black percs, niger trigger, mandarin 55 corner bowfront freshwater, African cichlids kessil a350 30 gal 36x36 coffee table fish tank. 3 red ear sliders. 5.5 gal nano, live rock, arrow crab, baby perc, firefish. |