JBJ ATO Switch Problem

Leah · #1 01-11-2010, 01:49 PM

How is the tank going?

When are you coming down? don't think I remember seeing you over Christmas or did you mean next Christmas, he he!

Oscar · #2 01-11-2010, 02:51 PM

I had sent you a couple of pms.

Leah · #3 01-11-2010, 02:54 PM

Are you serious, how did I miss it?

mseepman · #4 01-11-2010, 07:02 PM

Hmm, I use the same setup Oscar...not sure what to tell you. I do clean my floats about once every 6 months though.

Oscar · #5 01-11-2010, 10:08 PM

Probably just a cleaning of the contacts will do it.

#6 01-12-2010, 01:10 AM

I have the same setup works perfict just clean the floats in viniger and the contacts will need cleaning all surfaces if you need to clean the female conecter use a Qtip and perocide the perocide remove any corosion then rince with viniger and let dry. if that does not clear things up you will have to open the controler modual use perocide and clean the enitre circute board front and back close up and let dry. Test unit.

Bill

Oscar · #7 01-12-2010, 02:55 AM

Quote:

Originally Posted by bvlester

I have the same setup works perfict just clean the floats in viniger and the contacts will need cleaning all surfaces if you need to clean the female conecter use a Qtip and perocide the perocide remove any corosion then rince with viniger and let dry. if that does not clear things up you will have to open the controler modual use perocide and clean the enitre circute board front and back close up and let dry. Test unit.

Bill

Thanks. I think the connector to the controller should be ok since it is mounted in a nice dry spot inside the cabinet. But I will clean the float in vinegar tonight.