|
|
|
#11
11-04-2009, 04:41 AM
|
|||||
|
|||||
I definitely don't think that now. I drilled all my holes to be EXACT fits. The pvc is really stuck in place. I only used some epoxy to deal the top hole to keep creatures out. I have 100% faith in the pvc.
|
|
#12
11-04-2009, 04:45 AM
|
|||||
|
|||||
|
Quote:
Yeah I'm sure it will be fine. Your rock is quite flat as well and should not be a problem.
__________________
225g reef
|
|
#13
12-28-2009, 03:38 AM
|
||||
|
||||
|
zip ties
could someone explain the whole zip tie thing a bit better?? I understand the epoxy and the rods, but how do you use zip ties?? Im confused about that. wouldnt you see them?
|
|
#14
12-28-2009, 03:50 AM
|
|||||
|
|||||
|
If you spend many hours strategically drilling holes near contacting points in choice locations you can neatly hide all your zip ties. I couldn't really see any in my old setup.
Makes a really big mess...I did it right in the middle of my living room lol.
|
|
#15
12-28-2009, 03:54 AM
|
||||
|
||||
|
ok... so the rod goes through the rock, and then you drill another hole in the rod and rock and run a loop through the rod and into the rock?? that seems kinda redundant if your using a rod, epoxy and they`re stacked
|
|
#16
12-28-2009, 04:18 AM
|
|||||
|
|||||
|
use spray foam in the middle and top/bottom
__________________
180 starfire front, LPS, millipora Doesn't matter how much you have been reading until you take the plunge. You don't know as much as you think.
|
Linear Mode
