![]() |
|
#1
|
||||
|
||||
![]() I was expecting some new and exciting condiment....
|
#2
|
||||
|
||||
![]() Cant't help you there.. I found sketch-up hard to use.. lol.. So I used Revit Architecture to build my stand design...
I would just go through the help files to see if you can find your answer. |
#3
|
||||
|
||||
![]() I have a ruler and pencil/eraser combo that is foolproof.
will trade for frags ![]() |
#4
|
|||||
|
|||||
![]() I'm slowly getting the hang of it. Not extremely easy, but not as hard as Autocad LOL
__________________
Dan Pesonen Umm, a tank or 5 |
#5
|
||||
|
||||
![]() i actually found autocad easier than sketchup it took me over 3 hrs to design a tank poorly whereas i could have done an exact design through autocad in 30 minutes but i grew up using autocad versus playing with sketchup a few times.
|
#6
|
|||||
|
|||||
![]() Ya I'm self taught on AutoCad, so theres ALOT I dont know LOL. I mainly use it in 2D mode for my milling machine drawings
__________________
Dan Pesonen Umm, a tank or 5 |
#7
|
||||
|
||||
![]() autocad is absolutely amazing. if you have it i would concentrate your learning efforts on that vs sketchup
|
#8
|
|||||
|
|||||
![]() |