![]() |
|
#1
|
|||||
|
|||||
![]() Out of curiosity, what are you planning for a zeo reactor?
One thing about zeo that I found, is that you really need to get the flow rate right through the stones. I was considering zeo again for my solana but without a reactor, the flow rate through the back compartments (so running the stones "passively") was much too high and would probably starve the tank killing coral. Just curious if you have a DIY idea or found a small HOB reactor or something? I was also thinking about using a phosban reactor but then the only real way I could think of to do this is to shake the whole reactor each day...not gonna happen lol. |
#2
|
|||||
|
|||||
![]() Quote:
Otherwise somewhere in a media bag that is easy to reach everyday. Not all of the water flows through the same route in the compartments, so that is an option. Also building a basket of some sort to hold the media bag in a convenient spot could work. This question regarding zeolites and AIO tanks would be a good thread.
__________________
CadLights 39G Signature Series Started April, 2008 |
#3
|
|||||
|
|||||
![]() Quote:
But you can probably get some good advice about your specific system on the zeo forum. |
#4
|
|||||
|
|||||
![]() Quote:
Comments from: http://www.zeovit.com/forums/showthr...926#post182926 Hi Oscar, the maximum zeolite flow rate is 100gph per ltr. of zeolite used. Pro-rate to your net vol. Bob
__________________
CadLights 39G Signature Series Started April, 2008 |
#5
|
|||||
|
|||||
![]() Fyi, the higher the flow rate (like 100 gph per litre) the more aggressive the Zeolites are.
|
#6
|
|||||
|
|||||
![]() Yeah this is what I was getting at. I killed off a few corals when I started up because I had the flow rate wrong. It can cause problems very fast which is my concern for running the stones passively in the back of an AIO tank. If you get the flow rate right or on the low side, your ok but if you end up with too much flow, it can be very bad.
|
#7
|
|||||
|
|||||
![]() I was just trying to clarify what you said.
![]() |