|
|
|
|
|
#1
10-24-2009, 03:15 AM
|
|||||
|
|||||
I would calibrate both of them using 342 ppm NaCl califbration fluid, and then re-check. I know mine is difficult to calibrate (it's a $30 handheld)...so I wonder on its accuracy.
Last edited by Myka; 10-24-2009 at 03:17 AM. 
|
|
#2
10-25-2009, 03:34 AM
|
|||||
|
|||||
|
Thanks for the advice Mindy. Where's a good source for the calibration solution?
Not sure it's even worth calibrating the handheld, I think I paid less than $20 for it. My RO/DI system is barely six months old so I'm fairly confident in the Dual TDS meter that came with it, especially since both probes on that yielded identical readings for my source water. Being relatively new, I trust the RO and DI TDS readings since the filters should be nowhere near exhausted. My DI resin has only changed colour to about one quarter of the canister height. Besides, even if the readings are a little off at the low end, I'm not too concerned since I was using treated tap water up until six months ago.
__________________
Mike 77g sumpless SW DIY 10 watt multi-chip LED build  http://www.canreef.com/vbulletin/showthread.php?t=82206
Last edited by mike31154; 10-25-2009 at 03:37 AM.
|
Hybrid Mode
