|
|
|
|
|
#1
10-04-2009, 09:07 PM
|
|||||
|
|||||
wow sorry to hear about your troubles Hmmmm are you sure it was your tunze may be it was the phosban reactor that was leaking
__________________
180 starfire front, LPS, millipora Doesn't matter how much you have been reading until you take the plunge. You don't know as much as you think. 
|
|
#2
10-04-2009, 09:24 PM
|
|||||
|
|||||
|
I've been having trouble with the Tunze not working properly for a while now. The float sensor has been getting stuck in either the pump on/pump off position and the optical sensor only works when it feels like it. The phosban reactor is what caused the water on the floor, but the Tunze should have let me know that the water level in the sump was higher than normal when the return pump died.
__________________
120g build thread 48g-upgraded to 120g old pics old 48g build thread Pics.... more recent pics seahorse pics
|
|
#5
10-04-2009, 10:10 PM
|
|||||
|
|||||
|
This is usually how it works, one bad things leads to a whole open jar of nasty. No livestock was hurt from the overflow I hope?
Levi
|
|
#6
10-04-2009, 11:15 PM
|
|||||
|
|||||
|
clean your leveling sensor every odd day. mine builds up with salt creep and says its level when its not. its very sensitive so keep up on that. as for your warning noise when it passes your float sensor, check to see if it works. you just need to raise the sensor and it will make the noise. personally i love mine and makes my life a tad bit easier, and it just needs a clean every now and than
|
|
#7
10-05-2009, 02:39 AM
|
|||||
|
|||||
|
Sorry to hear, hope your day gets better. Tunze was really good with us, we had a part that wasn't working and we sent it to them and they shipped us out a brand new part right away with no problems.
__________________
One more fish should be ok?, right!!!  - Laurie
Last edited by fishoholic; 10-05-2009 at 05:15 AM.
|
Hybrid Mode
