|
|
|
#1
06-23-2003, 04:40 AM
|
|||||
|
|||||
Bored tonight.. So I made an LED moonlight for fun.
5 3200mcd LED's
6V 800mA supply. 5 x 220ohm resistors wired to cathodes. 1 x 1Kohm pot for dimming(temporary till a controller is built) three pieces of acrylic strip 3/4" wide for frame and shell. Last shot was taken at full intensity on a four second exposure. Really cool!!!!!!     
__________________
Darren Always strive for the optimum environment, not the minimum environment ----------------------------------- 
|
|
#2
06-23-2003, 04:46 AM
|
||||
|
||||
|
that is really cool. are you going to run them all to gether or are they going to be coming on in sequence?
__________________
Darin
|
|
#3
06-23-2003, 04:48 AM
|
|||||
|
|||||
|
For now all together. tho I am sure I could do a cool disco lighting sequence.
__________________
Darren Always strive for the optimum environment, not the minimum environment -----------------------------------
|
|
#8
06-23-2003, 01:15 PM
|
|||||
|
|||||
|
Darren what angle of spread are thease LED's? Also did you just drill two little holes in the acrylic and push them in?
As you probably know I have been farting around with LED's for a bit now and I have a large colection of them. the problem I am at is I think the narrow beem LED's are to focused for a night light (you end up with spot lights) so I have ordered some high intensity wide angle ones.. hope they will work better. Also I am curious as to whi you didn;t use the Luston Star you have.. I think that it with out the lense would give a nice wide spread, or was it to bright? Steve
__________________
 *everything said above is just my opinion, and may or may not reflect the views of this BBS, its Operators, and its Members. If cornered on any “opinion” I post I will totally deny having ever said this in a Court of Law…Unless I am the right one*Some strive to be perfect.... I just strive.
|
|
#9
06-23-2003, 01:32 PM
|
|||||
|
|||||
|
Steve,
For the spread problem I aimed them at the roof of the lid. Provides perfect dispersion. No spotlights.  If I want a disco effect I rotate it so the LEDs point into the water. I just drilled 3/16th holes and then a countersink 13/16 holes partway in so the LED's protrude from the acrylic.Haven't had a chance to use the Stars yet. I want to build an adjustable constant current source for them. Much easier to control.
__________________
Darren Always strive for the optimum environment, not the minimum environment -----------------------------------
|
Linear Mode
