150g Cube Build - New Pics

[Pazil]

Here are some pics of the prgress so far.... I have to get the sump fixed so I just basically ran the plumbing around where it will go until I get it fixed and in place.. Then I will plumb it into the system and move all of the equipment into it. The tank and area is pretty messy right now but will look much better once everything is finished.

Full tank shots




New baracuda pump



Here is where the sump will be placed

[sharuq1]

Sorry to hear about your sump cracking. On the upside, good job plumbing!

[Pazil]

Sump is not too big of a deal.. I picked up the side panels yesterday and repaired it... Just waiting for the silicon to dry to do a leak test (fingers crossed) and hopefully I can finish the project on the weekend.

[fishytime]

Man you dont fart around do you? "Git er dun" I am gonna have to pop over sometime....looks sweet bud.

[Pazil]

Well I finally got around to getting some pics of the sump/fowlr setup.... After setting up the new tank and plumbing the sump into it... I decided to ditch the sump and just use the 110g. for the sump and fowlr kind of as a all-in-one setup. So I now have the 150g. cube plumbed down into the basement and using the 110g. as the sump/fowlr. I have added 2 TLF reactors of carbon and GFO, about 100 lbs of LR and moved everything else from the old sump over to this one. The only inhabitants in there so far are, 1.5" clown trigger, 3" huma huma trigger, 3.5" puffer, and a 3.5" yellow tang. I could not get a good pic of the tang. Here are a few pics of the setup in the basement.

[lobsterboy]

lookin pretty sweet bah

[kien]

very cool! except now you have to go into the basement to feed your sump! hehe! Love those triggers though.