|
|
|
#11
05-28-2009, 01:41 PM
|
|||||
|
|||||
Hi
The unit runs on 1-10V. As the DC voltage increases so does the AC output, so the unit has to be set to 1.5V as a base line to stop lamp flicker and then you can adjust from there On the 54w ballasts we found the best curve was 0-50% after that you only gain 10% BUT you have heaps to play with in this 50%. As for ballasts you can have 24w 39w 54w and 80w all in 110V So if you want dimmable lighting in all wattages but do not have a Profilux..... Time to get one  The Profilux light II controller will also control these power bars and ballasts!!!! Where to get the ballasts - Do a search for Philips advance mark 10 also Sylvania do them. We have one dealer with them in stock for now if you email me i will give you the details. |
|
#12
05-28-2009, 02:21 PM
|
|||||
|
|||||
|
Do these ballasts use a 0-10V control input or just vary the 110v mains to dim the light?
__________________
Dan Pesonen Umm, a tank or 5 |
|
#13
05-28-2009, 02:40 PM
|
|||||
|
|||||
|
Hiya
They work by varying the AC input voltage. The data cable of the power bar plugs into a 1-10V line on the back of the profilux and the ballast AC plugs into the power bar. WARNING - DO NOT plug the "Dimmable" power bar into an "S" socket on the ProfiLux, seriously - Don't  The beauty of these ballasts is 1. Far less wiring 2. Available in all wattages in 110V |
Linear Mode
