Why is my MJ1200 with SureFlow mod doing this?

fkshiu · #1 05-26-2009, 05:18 AM

Quote:

Originally Posted by Myka

Well, it was freakin difficult to get that propeller off the shaft and turn it around, so I'm assuming that no one took it off and put it back on backwards, so that makes me think that the propeller is spinning in the opposite way that is was intended. If you look at the propeller from the front it is spinning counter-clockwise. It spins the same way every time I plug it in.

Oh, and the frickin thing is going to be banned to salt mixing as soon as I find a replacement. It is obnoxiously loud. Grr.

The flat side of the propellor should be in front.

If it is facing correctly, then you should try shaving the propellor down a bit with a dremel tool to make it smaller.

Myka · #2 05-26-2009, 05:25 AM

Oops, I forgot to mention that it is pushing water out, not sucking it in. It has never made the water go backwards. The tabs get in the way, and don't allow the prop to spin that way.

fkshiu: I'm not sure what you mean about the flat side in front? Do you mean the flatter edge of each petal should be leading the spin, not following?

The guy I bought it off is sending me the black propeller, so hopefully that one will work better.

fkshiu · #3 05-26-2009, 05:31 AM

Quote:

Originally Posted by Myka

Oops, I forgot to mention that it is pushing water out, not sucking it in. It has never made the water go backwards. The tabs get in the way, and don't allow the prop to spin that way.

fkshiu: I'm not sure what you mean about the flat side in front? Do you mean the flatter edge of each petal should be leading the spin, not following?

The guy I bought it off is sending me the black propeller, so hopefully that one will work better.

Go back to page 1 of this thread and look at Mike31154's pictures. The top picture shows the correction propellor orientation.

If you put the black one in a Maxijet 900 it should definitely work better although you won't get quite as much flow.

Myka · #4 05-26-2009, 05:51 AM

I will check the prop orientation tomorrow when the lights are on. I would rather have less flow than all this noise. I just need to get by for a couple months or so. Good thing I have LPS, not SPS!

dsaundry · #5 05-26-2009, 03:35 PM

Taggin along, my MJ mod actually spins the cover off sometimes..

Myka · #6 05-26-2009, 03:40 PM

Fkshiu, the orientation of the propeller is backwards now that I have flipped it around. The flat side is following, not leading. It won't work with the flat side leading. So that would further point to the fact that the propeller is actually spinning the "wrong" way right?

mike31154 · #7 05-26-2009, 04:21 PM

Quote:

Originally Posted by Myka

Fkshiu, the orientation of the propeller is backwards now that I have flipped it around. The flat side is following, not leading. It won't work with the flat side leading. So that would further point to the fact that the propeller is actually spinning the "wrong" way right?

Ha, ha, so my assumption was incorrect in that it may have been flipped around, so much for my brilliance! It 'should' work more efficiently if you return it to the original orientation, but that seemed to give you more grief than the current config...

In any case, either way the propeller is flipped, provided it spins counter clockwise (and the tabs take care of that), it will push water out the front, as intended. The flat side leading is supposedly the correct orientation, but who knows... it's now once again a mystery.