|
|
|
|
|
#1
04-13-2009, 10:52 PM
|
|||||
|
|||||
Quote:
Real epoxy applied while dry and allowed to cure overnight maybe and/or gobs of Superglue perhaps too.
__________________
|
|
#2
04-13-2009, 11:05 PM
|
|||||
|
|||||
|
An acrylic adhesive like Weldon will be the safest bet. Needs to air cure for 24 hrs though. Hold one, edit... if you can get hold of some nylon hardware, screw/nut, would that do the trick? Or even a zip tie or two in the meantime...
__________________
Mike 77g sumpless SW DIY 10 watt multi-chip LED build  http://www.canreef.com/vbulletin/showthread.php?t=82206
Last edited by mike31154; 04-13-2009 at 11:08 PM.
|
|
#3
04-13-2009, 11:36 PM
|
||||
|
||||
|
Thanks for the quick responses. I have tried coral epoxy for now. I have found a product called GOLD LABEL UNDERWATER SEALER but so far it seems like it is only available in the UK. Looks like amazing stuff tho. I have a week off in May, I may try to drain the tank a little and seal it with silicone then.
|
|
#5
04-14-2009, 10:57 AM
|
||||
|
||||
|
Wow, I'm on a roll today. I was just reading about complete glass replacements on WWM and ran across your problem. I have never owned an acrylic tank, so I have not researched it (and really can not offer much advice) but to look here. http://www.wetwebmedia.com/acrylictkrepfaqs.htm It is a bunch of questions that have been asked about how to fix problems on acrylic tanks. If your question is not answered, there is another page of FAQ's on the same site.
Good luck
__________________
"Government is the great fiction, through which everybody endeavors to live at the expense of everybody else." -- Frederick Bastiat
|
Hybrid Mode
