|
|
|
|
|
#1
04-01-2009, 02:54 AM
|
||||
|
||||
Thats about what I have been doing, with those breakaway, olfa knives, just taking a break right now. Its the edges that I am worried about. Was going to try some sandpaper. Because of the black plastic frame, the glass has sharp edges. Not easy to clean with a knife because the edge is actually concave. But I like the steel brush idea, will try that too.
Tomorrow I will see what is left and see if I can find that remover from rona. I was at rona yesterday looking for that GE 1200 but they didn't have it. Thanks for the info, looks like elbow grease tonight. 
|
|
#2
04-01-2009, 05:39 AM
|
|||||
|
|||||
|
Best bet is to just use razor blades and brass wire brush. Chemicals can make a mess of silicone, it gets all gummy and not fun. Use acetone to clean the joint thoroughly before silicone. Hit up some glass shops or lfs to find ge cs1200
__________________
28g Nano Cube drilled with 13g sump in stock stand. Vertex IN80 Skimmer, Phosban 150 Reactor, Apex Controller, DIY LED with stock hood, dimmable Established March 2006
|
Hybrid Mode
