Freak'n Scarry discovery

fishoholic · #1 03-09-2009, 08:35 PM

Yikes, good luck, I hope it works out for you.

cprowler · #2 03-09-2009, 08:54 PM

Is it just the teeth that need to be trimmed on the front and/or back?

If it's just a few teeth you may get through it with out melting too much, if you can get in there. Using a hacksaw blade might work the best, I have a bunch of new blades including some very fine toothed ones.

LMK if you want me to bring them over.

Jason McK · #3 03-09-2009, 09:29 PM

Hey Cprowler thank for finding the pic. You can see where the brace goes over the teeth. It's gonna be though to get in there.

After thinking this through all day. I think it's always been like that. Last week I was hanging in the tank quite a bit and might have put a lot of pressure on the back brace. This could have cause it to crack.

I'll follow up in the morning with my progress

J

Jason McK · #4 03-09-2009, 09:29 PM

Yes both front and back. The back is cracked but the front is flexed quite a bit.

J

FBNitro · #5 03-10-2009, 07:43 PM

Maybe you could use a Dremel to get at it, might be easier to maneuver than a hacksaw.

Edit: Apparently I can't read, already been suggested, twice. <sigh>

Jason McK · #6 03-10-2009, 07:49 PM

I may just leave it to see if it gets worse. That way I would know there is a problem instead of cutting the teeth only to mask the problem untill it's too late.

J