![]() |
#61
|
|||||
|
|||||
![]() Prams Jan 19
Ca...450 ppm Mg...1400 Potassium....340 mg/l pH...7.99 dKH.....7.4 Phosphate...less than 0.3ppm Nitrates....less than 0.2 ppm Salinity 31 ppt ... a little high will lower Conductivity.....53.5 mEq Redox...avg 337 mV( would like it higher) I would like to review: Currently I am dosing: PT 1.........5ml PT 2.........10ml PT 3.........10ml PT 4.........5ml MinS.......3ml Bak...........0.5ml Bio............4 drops every 3 days zeolite........0.5 l...have not changed yet Amin...........not dosing Organic ......not dosing 10% water change/week Carbon change one / month Phosphate remover......not using Claude... Should I continue this dosing rate? When should I adjust the power trace dosing(what are my indicators)? |
#62
|
||||
|
||||
![]() Hi Fencer
Please use same dosing reduce the Bio to 4 drops weekly Did you filtered over carbon ? if yes how much and which changes ? Redox is ok Salinity can be better at 34 but iám wondering why you MG and CA is so high ? greets claude |
#63
|
|||||
|
|||||
![]() Hi Claude
Same dosing. Dropping Bio to 4 drops weekly. I will raise salinity to 34. I use one litre of Carbon in a reactor. The reactor sits in the sump and only feeds back into the sump. In other words the carbon filtered water never goes in the main tank directly. The carbon reactor pump flows about 100 l/ hr. As for the Mg and Ca. My Mg has always been high and the Ca is due to the new salt being used. I could slow down the Ca reactor flow. But the Ca has remained constant( I have been testing this every day since I started using the new salt) |
#64
|
||||
|
||||
![]() HI Fencer
which kind of carbon you use what make your corals greets claude |
#65
|
|||||
|
|||||
![]() Hi Claude
I am using Kent Marine Reef Carbon I am not sure what you are asking, "what make your corals" please clarify - I have 85 % sps in the tank mostly acropora sp(60%) but also have other sps species in the tank -any recommendations? Other notes 1. I have noticed my pod population has dropped drastically 2. I was moving some rock work in the main tank and caused most of the acros to start releasing "slime" into the tank. This was enough toxin released in the tank to cause signifigant tissue loss in the montis, birdsnest and echino. Pollioporas suffered tissue loss to a lesser extent. LESSON: never do aggressive landscaping in the tank when you have a lot of sps. Last edited by fencer; 02-12-2009 at 08:23 PM. |
#66
|
|||||
|
|||||
![]() Hiya
Claude means what breed of corals etc |
#67
|
||||
|
||||
![]() IH Fencer
hmm i did not know this carbon it is pelltized or small granule ? Please check the Ph swing and Po4 level of this carbon you are right a massive landscaping can bring a loto f problems check here also your Po4 level with a heat test greets claude |
#68
|
|||||
|
|||||
![]() Hi Claude
This is a pellet type carbon...I suspect it is pH 7 or higher as is safe for reef and cichlid use. I checked it for phosphates and it did not show any trace. pH swing was also small. As a result of that moving rock around I did lose one SPS by STN others were damaged but have recovered. Water tests to come on Friday/Sat. Here are some comparison photos: ![]() ![]() ![]() Here is all the images from the day ultra was started; http://s496.photobucket.com/albums/r...view=slideshow Last edited by fencer; 03-11-2009 at 06:33 AM. |
#69
|
|||||
|
|||||
![]() The Monti on the upper right side of this photo has not responded to Ultralith. O suspect it might be the light also:
![]() |
#70
|
|||||
|
|||||
![]() I would like to review:
Currently I am dosing as of Mar 10th: PT 1.........5ml PT 2.........10ml PT 3.........10ml PT 4.........5ml MinS.......3ml Bak...........0.5ml Bio............4 drops every week zeolite........0.5 l...have not changed yet Amin...........not dosing Organic ......not dosing 10% water change/week Carbon change one / month Phosphate remover......not using Claude... Should I continue this dosing rate? When should I adjust the power trace dosing(what are my indicators)? Last edited by fencer; 03-11-2009 at 02:31 PM. |