crabs new 24" cube

[i have crabs]

went and picked up the sump and thankfull it fit through th back of the stand without a problem since i made it as big as possible,
its 19"x20" and 18" tall,
the 2 holes are for the drains then they pour into the skimmer area which pours into the return pump area, the space in the right back corner is a small fuge which will have water pumped through the bulkhead and overflow back into the return pump area


thankfully the skimmer fit also since i didnt leave much extra room and i ordered the sump before buying the skimmer

[i have crabs]

ill be finishing the plumbing over the next few days i hope but for now im gonna try to cover the back pain of glass and overflow with rocks,
i went and bought a cut off disk for a hand grinder i have.id rather use a big chop saw but i dont have one and im not gonna go buy one unless i have too
first step was trying to cut a rock in half without losing my fingers, for my test run i cut up a reef rock which is fairly solid but still didnt go all that bad, wasnt much fun but i was shure not to wear any safty equipment or proper tools so that helped im shure




the black crud washed right off no prob

i have some extra glass lids so im trying to attach the pieces so i can find out if this is even going to work or not, first piece i glued with mr.sticky which is a epoxy type glue
the second piece i used deltec epoxy and i had another flat piece that i tried to silicone
so im not gonna touch it till morning and hopefully one of the 3 will work like majic