Need RO set up help...

[mark]

here's a link (with picture) to that saddle tee for your drain.

[GreenSpottedPuffer]

Originally Posted by mark

here's a link (with picture) to that saddle tee for your drain.

I am really missing something though...how is that used??

Sorry, I know I am asking a million question but I have no idea about this stuff. Actually the concept of its fine but finding the right fittings has been impossible so far...

[mark]

Originally Posted by GreenSpottedPuffer

I am really missing something though...how is that used??

Sorry, I know I am asking a million question but I have no idea about this stuff. Actually the concept of its fine but finding the right fittings has been impossible so far...

Below the fitting for your dishwasher drill a hole, put the clamp over an tighten, insert the waste line from you ro unit, done. Would route the waste water line similiar to your dishwasher (a upward loop).

[GreenSpottedPuffer]

Originally Posted by mark

Below the fitting for your dishwasher drill a hole, put the clamp over an tighten, insert the waste line from you ro unit, done. Would route the waste water line similiar to your dishwasher (a upward loop).

Ok....I will take a picture then because I don't know exactly how that will work. I understand drilling the hole (I guess the diameter of the tubing?) and then using the clamp but the tubing doesn't go all the way through the clamp, so would not reach the drilled hole. Obviously thats not a good thing

There is a little tiny white piece that came with that clamp but I don't see how that would help. Must be needed though. As well it has a little piece of foam I think...

[mark]

Same way the piercing valve works. The white foam is a gasket that goes between the pipe and the clamp (like the black rubber in the picture). The ro tube doesn't need to go all the way into the hole in the drain, just seat it in the connector, but obviously the holes need to line up.

[GreenSpottedPuffer]

Ok, thanks...

SO I used a brass "T" from that shut off valve that was already there that Tees up to the faucet and also to the RO unit...It says its a compression fitting and the guy at HD said all I need to do is insert the tubing and then tighten the nut. I have done that but it leaks. Am I missing something? Was there suppose to be a washer or something? Or have I probably just not tightened it enough?

I also realized that having this hooked up to the coldwater line means I am using very cold water. I though to make RO water it was suppose to be around 70-75 degrees? Am I wrong?

[GreenSpottedPuffer]

BTW thanks for all your help guys!