|
|
|
|
|
#1
12-04-2008, 11:12 PM
|
||||
|
||||
I helped (well more like held the template) Ant a couple months back.
Seems pretty straight forward. I'd get him to supervise me though...... since I've never actually done the drilling. Cheers, Vic 
|
|
#2
12-04-2008, 11:47 PM
|
|||||
|
|||||
|
Drilling isn't as bad as you might think, but you have to be very good with a drill to free hand it.
You need to drill the whole way as close to 90 degrees as possible, otherwise you are going to get 'blow out' on the backside of the hole. Last night I was drilling a 20g, 3 holes .. Almost zero blow out, I was impressed! (Tank #6 under my belt), but of course there is drill from both sides, but very difficult. BTW: Get the bulk head before you drill. Depends on the style, they need different hole sizes.
__________________
28g Nano Cube drilled with 13g sump in stock stand. Vertex IN80 Skimmer, Phosban 150 Reactor, Apex Controller, DIY LED with stock hood, dimmable Established March 2006
|
|
#3
12-05-2008, 12:11 AM
|
|||||
|
|||||
|
Thanks guys. I had already spoken to Anthony and he is going to try to make it over to my place to drill it when he has time.
|
Hybrid Mode
