![]() |
|
#1
|
|||||
|
|||||
![]() Quote:
It should say right on the bulkhead though. The hole in the glass will be a bit bigger than the bulkhead size. |
#2
|
||||
|
||||
![]() I have one that is just shy of 1-3/8 slip for (inside of tank) and just slightly larger than
1-1/4 threaded on the part that goes outside of tank. The pipe that is threaded, that goes into that is OD 1-1/4 Live in Surrey though |
#3
|
|||||
|
|||||
![]() Quote:
The slip side must be for 1-1/4 though don't you think? I mean there is no PVC that is 1-3/8. It is either 1.25 or 1.5". Does the back (or threaded side) fit a 1-1/4" pipe inside? Surrey might be fine...I don't have a choice. EDIT: If I remember correctly, the dimensions are never exactly 1-1/4 so that would make sense. If the dimensions are that close to 1-1/4" it must be made for 1-1/4" pipe. I will PM you. Thanks so much for responding! |
#4
|
||||
|
||||
![]() I really get confused on pipe, never know if it is measured ID or OD
Anyway, the slip is 1-1/4 OD pipe and the threaded side would be for 1 inch ID pipe. And it fits into a 1-3/4 inch hole in the aquarium glass I pmd you |
#5
|
||||
|
||||
![]() I have one I could over night purolator if it is an emergency.
Kevin |
#6
|
|||||
|
|||||
![]() Quote:
Thanks for the offer and I will let you know if this other one doesn't work out. We are just trying to figure out if its got the right dimensions. |
#7
|
|||||
|
|||||
![]() Found one thanks!
|