Ghl Profilux Discussion And Support Thread

[Todd]

I am having problems getting my float valves to work. I have two valves on a splitter and the computer recognizes that I have two of them (as when I disconnect them it acts differently). But I cannot get the computer to realize the float is floating (ie tank is full), it will continue to run untill I get a time out alarm.

I have tried it with only one float and no splitter, the other with no splitter, both with the splitter. Plugging one in and resetting the computer then trying - all the same result, it will not recognize when it the valve is floating (ie when to shut off the pump). I recently had one of the valves replaced under warranty (through progressive reef). Both of the valves are clean.

I also tried upgrading to Firmware 4.04 and software 4.0.3.0 hoping that would solve things, no to no avail.

Any suggestions?

[Aqua-Digital]

Hi

Does it work when plugged in independantly

[Todd]

No, it recognizes that only one valve is plugged in, but it will not register that it is 'full' and switch off.

[Patrick1]

What is your delay setting time at?

[Todd]

It was 2 seconds, but I moved it to 0 seconds while I was trying them.

[Aqua-Digital]

Pop it into Spensor at PG

[Todd]

Originally Posted by Aqua-Digital

Pop it into Spensor at PG

The Sensors or the computer unit?