Ghl Profilux Discussion And Support Thread

[Jason McK]

I assume the Extension mode measures the temp and the resistance in the cable before you add the extension. Then through the mode you tell the unit you just added the extension and it measures again. then calculates the difference and increases the signal voltage to compensate.

OK, I'll wait for Matthias

Thanks

[bullit67]

Hi Michael

I have a bit of a problem I was having problems with the software on my lap top so I so I loaded up the new 4.0 version well now I cant connect to the controller it tells me I need a lower version of the software. I can not find any where to download a lower version of the software.

thanks for your time

Doug

[Aqua-Digital]

To go from 3.08 firmware to 4.0 you must do the following

Install firmware version 4.0 first

then

Install software version 4.0

Never do the other way round.

You also can not run version 4.0 software without loading the firmware either

[bullit67]

yah But I goofed and installed the software first as I was having problems with the 3.8 software I need to get the 3.8 version of the software back so I can do the upgrade but I cant find any place to download it

[Aqua-Digital]

CLICK THE CRAB

[bullit67]

Oh man I looked there and did find it but I guess I didnt look close enough because I found it now. I guess I should of put my glasses on sooner

Thanks again

Doug