|
|
|
|
|
#1
08-21-2008, 05:28 AM
|
||||
|
||||
Just a thought,but maybe it was in the backflush position to begin with or there are particles from the new filter / old ro membrane ( if it had dried out ).
__________________
Sebae 
|
|
#2
08-21-2008, 02:51 PM
|
||||
|
||||
|
I don't know what you mean by back flushing???
I hope you don't mean you are trying to push water through it from the exit? If you did this you probably ruined your membrain. What you want to to is flush the membrain. flushing works by bypassing the flow restrictor on your RO system and allowing a fast high speed flow of water to pass over the membrane surface and clean off any debris or scale that would otherwise clogg and shorten the life span of your RO membrane.
__________________
75g 24x30x24 w/external overflow 35 sump/fuge 250w Ice Cap MH with Radium 20k & Luminarc Reflector PS4 Return -PCI Chiller - WavySea 2 x Tunze 6101 H&S A150-2001 2 x Deltec Reactors Carbon/Phosban Profilux Plus II
|
|
#3
08-21-2008, 02:58 PM
|
||||
|
||||
|
If you don't have a flush kit and want to do it mannualy, you have to take out the flow restrictor and then let the water flow as it does regularily but at a higher speed.
or you could grab one of these: http://www.shopbwirrigation.com/inde...&productId=406
__________________
75g 24x30x24 w/external overflow 35 sump/fuge 250w Ice Cap MH with Radium 20k & Luminarc Reflector PS4 Return -PCI Chiller - WavySea 2 x Tunze 6101 H&S A150-2001 2 x Deltec Reactors Carbon/Phosban Profilux Plus II
|
Hybrid Mode
