|
|
|
|
|
#1
04-30-2008, 05:06 AM
|
||||
|
||||
Beautiful work Chin.
__________________
If you see it, can take care of it, better get it or put it on hold. Otherwise, it'll be gone & you'll regret it! 
|
|
#2
04-30-2008, 05:23 AM
|
|||||
|
|||||
|
Neat. Where's the probe holder? (Sorry if I'm just daft - but I don't see it?) What did you use for a probe holder?
How does the media chamber thing work? Is it basically some 5.5" tubing inside some 6" or something like that?
__________________
-- Tony My next hobby will be flooding my basement while repeatedly banging my head against a brick wall and tearing up $100 bills. Whee!
|
|
#3
04-30-2008, 05:44 AM
|
|||||
|
|||||
|
Mark
I bolted the lid onto a flange so the holes are all aligned. Then I used a heat gun to heat both sides until slightly soft and then pushed it down on a piece of 2 inch coupling through the flange. Tony The probe holder is sticking out through the side of the upflow tubing. I put it there so its out of the way where I won`t need access to the reactor. I used a half inch gland nut that had a male NPT which screwed into a FPT fitting. The bottom of the media chamber is an acrylic doughnut that has a 2-3 inch hole in the middle and this ring is glued into place. I cut eggcrate to fit on top of the doughnut, then two layers of enkamat, and another doughnut to squish the enkamat down. When I want to remove the chamber, I drain water until its below the flange, unscrew the nylon bolts, and unscrew the top union.
__________________
____________ If people don't die, it wouldn't make living important. And why do we fall? So we can learn to pick ourselves up.
|
|
#6
04-30-2008, 12:48 PM
|
|||||
|
|||||
|
Nice work. Are you going to be able to pull that probe out easily for recalibration?
__________________
400 gal reef. Established April, 2007. 3 Sequence Dart, RM12-4 skimmer, 2 x OM4Ways, Yellow Tang, Maroon Clown (pair), Blonde Naso Tang, Vlamingi Tang, Foxface Rabbit, Unicorn Tang, 2 Pakistani Butterflies and a few coral gobies My Tank: http://www.canreef.com/vbulletin/showthread.php?t=28436
|
Great looking work Chin. I dont know how you guys do that. 
Hybrid Mode
