Do you need your tank drilled? (Okanagan)

[Myka]

Weird...I can get the first page, but as soon as I click on any link on the site I get a page that says:

E:\home\dancole\website\cgi-bin\SoftCart.exe Internal Exception Error c0000005

[Starry]

I get the same thing, and have been for a few months.

[mseepman]

How much are the professional ones?

[wolf_bluejay]

I found that the "tool place" in Kamloops had pretty good bits and a good range of sizes for about $20 each (for the 2.5" I bought). As for the rig.... I just drilled a piece of acrylic sheet first, then clamped on the glass to hold the bit in place for the first while.

A real good drill is the only needed expensive part. You need one with very fine control over the speed. You can always have your cheap bit re-coated if you actually wear it out. But you have to drill a lot for that to happen.

[Myka]

I thought I tried The Tool Place, but now that I think of it, they were closed when I went there. I'll have to try again. Good idea with te acrylic!! Ya, I have a good Makita drill.

[Gools]

I have a bit to drill a 1.5 bulkhead. Have drilled several holes in my tank. Very easy to do.

[Myka]

Ya, it's not hard. I need to drill for 3/4" and 1" bulkheads, so I need 1 1/2" and 1 3/4" bits.