RODI problem

[Chowder]

I am in a appartment and I don't have a outside hose bib. I couldn't get an accurate reading with the PSI meter because the fitting leaked to much. I could read 40 PSI but there was water spraying everywhere. I assume it would be higher if I could get a good seal.
Thanks, Chris

[Sebae again]

Maybe some DI beads got into somewhere. I assume you have back flushed the system.If you used a needle valve on the supply some sediment or rust could have gotten in there.You may have to take all the lines apart and flush each one out seperate.

[Chowder]

I took apart the unit this morning. I cleaned out all the beads made sure all lines were unblocked. I started the unit earlier about 7-8 hours ago and am at about 2 gallons. I also emailed Aquasafe and am waiting to see what they say.
Thanks, Chris

[Captainhemo]

try remving all the pre filters, the membrane, and Di . Then see if water passes freely through the system. If so, start adding filters , starting at prefilter until you find the problem.

[Chowder]

Didn't think of that good idea. I will try that tomorrow when I get off work.
Thanks, Chris

[littlesilvermax]

My guess is the carbon filter is put in upside down. A common mistake. It looks like it should go in that way, but looks can be deceiving.

I have made that mistake before.

[Chowder]

Hey figured out the problem today. It was the carbon block filter. It was not allowing any water to pass through. Did not work either way I put it in. Replaced it with a new filter and runs fine now. Thanks everyone for your help.
Chris