new sump= Major problems

Black Phantom · #1 04-05-2008, 10:40 PM

There must be another reason for the heat buildup. Apart from lights and a heater the only other source is your pump. Put your hand on it to see if it's overheating.
As far as all the humidity you're getting I'm not sure what could be going on there. I regularly run my tank at 81 and the tank is behind a display wall so the room isn't that large. My total water volume is a little over 350 gallons and I don't have a problem with humidity.
I just make sure I get good airflow to the room.

untamed · #2 04-05-2008, 11:15 PM

I'm guessing that the fan is new....added because you are trying to cool things down. It's the evaporation caused by the fan that is sweating the walls.

That's no answer as to what is causing your heat buildup though...

Ghost · #3 12-18-2008, 02:58 PM

Chevyjaxon.... did you ever find out what caused the problem? I know this is an old thread, but I've just joined the site, am a newcomer to the hobby, and am having a similar problem.

I have a 110g tank w/sump, Rio 26H, submersed heater set at 74 degrees (in sump) and temp is sitting at 82-83degrees and this is without any lights on. So far I've only added sand and fresh water to make sure everything worked well and won't add any live rock to start the cycle until I can stabilize the first issue.

If anyone else has any suggestions, I'd appreciate them. I unplugged the heater and the two power heads yesterday just to see if I can isolate the problem. So far it has gone from 83 degrees yesterday to 80.6 as of this morning.

I thought perhaps it could be the back pressure in the Rio pump because the return outlet on the pump is 3/4" and my return (flex tube) is also 3/4" so I was told to use 1/2" connectors to get the two to join. But I've called the pet store and they have told me that even with that bottleneck the temperature could not possibly soar 9 degrees up from just the pump.

PS - All equipment is new.

brizzo · #4 12-18-2008, 03:49 PM

Did either of you check if your thermometer is actually accurate, or use more than one?? Just a stab in the dark

Ghost · #5 12-18-2008, 04:15 PM

I am going to double check mine this evening with another one. The one I have in there now is a digital type with the cord submersed in the tank. Being that I bought it brand new and saw it climb (when I first added colder water) and plateau, I would think it is. But I'm going to double check everything. If I spent a ton of time trying to figure this out only to learn it was something that simple; I'd go postal.

dabandit · #6 12-18-2008, 04:18 PM

Off the top of my head evap could be caused by added turbulence due to extra baffles,smaller pump out chamber can cause extra heat,new fuge light could cause extra heat and the fan itself can cause extra evap. Somethings to think about

superduperwesman · #7 12-18-2008, 04:31 PM

I have a fairly new thermometer that is out by 3 degrees. Unfortunately I tossed the receipt so I can't return it. It's the type that works of a temp probe that you submerge

fkshiu · #8 12-18-2008, 05:17 PM

Get several thermometers and make sure they all agree.

Place them throughout your system.

Unplug each electrical device starting with your heater(s) one by one each hour or so and closely monitor the thermometers. Unplug your return pump last.

OR it could be that with the added humidity in the general vicinity the evap rate is being limited thereby leading to an increase in temp. Solution? Open some windows.