|
|
|
|
|
#1
04-02-2008, 05:15 AM
|
|||||
|
|||||
Quote:
The right blade its never been a problem for me cut it all the time at work. Its just plastic.  Acrylic cuts just as well as UHMW or polycarb it is just more brittle.
__________________
150 Gal system 3'x3' 400W M/H, Bekett skimmer, Dart return,1/4 HP Chiller 180 Gal Drop tank, LED lights, Bubble master 250 skimmer,Hammerhead on a closed loop, Speed wave return. 
|
|
#2
04-02-2008, 04:02 PM
|
||||
|
||||
|
Because it is brittle and so it tends to spider-web and at times even chip. Maybe it was just me and quite possibly just the wrong blade! LOL! However there is constant contact with a hole saw's teeth and so it scrapes/peels away, like a planer; less stress on the acrylic sheet. Just my 2 cents and experience.
I guess, upon reflection, I'm not that fond of hand held jig saws.
|
|
#3
04-02-2008, 04:10 PM
|
||||
|
||||
|
I'd have to second BC Mosaic's comments on the jigsaw. It probably works, but the back-and-forth motion pushes and pulls the acrylic, creating unnecessary stress on it. Anything that rotates should be better.
Regards, Nevin
|
Hybrid Mode
