Sound absorption panels for unside stand??

[kwirky]

i've used DynaMat. It's like a compressed tar material. Didn't work on computers very well.

[banditpowdercoat]

Dynamat is more for deep, low frequency sounds. Not fans and Pumps. I have installed many pounds of Dynamat in my vehicles

[mastergunsg]

Dyna mat is a Damper by far the most common type of material. It uses mass loading to lower panel resonance and absorb structural vibrations

then there are absorber's usually an open/closed cell foam. this slows the transmission of the sound.

barrier's are usually a heavy material like hi density glass reinforced rubber or even lead, a barrier is usually around 1 pound per square foot.

By using these three materials in conjunction with each other produces the best results. You can buy composite materials but they usually are pretty expensive IMO. as i like to do things as frugally as possible

I'm going to try using some common construction materials that are readily available to be used as dampeners and absorbers. They wont work as well as materials designed specifically for reducing noise but i can probably get them cheap or even free as waste from some of the job sites I'm usually on. I might break down and buy a barrier to go along with the other materials as I would like my tank as silent as possible, but i haven't decided yet. I will let you guys know how things work out and if the materials do work well ill post with the brand names of the items for you all to try.

[banditpowdercoat]

Ya, Dynamat adds MASS to whatever its attached to, makes that harder to vibrate with sound waves. I am looking for Absorbing. Like the eggcrate type foam that you see in anechoic chambers used for sound measuring.

[mastergunsg]

The egg crate type foam helps with reduction Hi frequency sound waves reflecting off of surfaces (echo)and thats why its so good for sound measuring rooms,but as its a lightweight open cell foam it wont do much for the reduction of sound waves transmitting Through the surfaces of the stand itself. Thats why i would like to try a few different materials, in layers as this is the best method for reducing sound. I have seen a few products that i believe that will work well. I just cant remember the brand names or where to get them here in Vancouver i know they are available as i see them on allot of different job sites. So ill make some inquiries when I go to work on Monday.