|
|
|
|
|
#3
12-12-2007, 02:14 PM
|
|||||
|
|||||
Good job Ande. I'll take one too.
__________________
M2CW 
|
|
#5
12-12-2007, 02:26 PM
|
|||||
|
|||||
|
Umm...I'll take one, too? I see a business opportunity
__________________
~Drew 10G Nano * 10G Sump * Deltec MCE 600 Skimmer * JBL Viper 150w MH * Zeovit * Vortech MP40W Millions long for immortality who do not know what to do with themselves on a rainy Sunday afternoon. ~S. Ertz 
|
|
#6
12-12-2007, 02:43 PM
|
|||||
|
|||||
|
I'd buy one!
Sounds like you have a new source of income
__________________
- Greg 90G : Light - Tek 6xT5 | Skim - EuroReef RS135 | Flow - 2xVortech MP40W | Control - Reef Keeper 2
|
|
#7
12-12-2007, 04:21 PM
|
|||||
|
|||||
|
Your ZEOvit Reactor looks great.
When you set it up to run keep in mind the suggested flow rates in the ZEOvit Guide. It is important to have sufficient water flow through the filter material (200-400 liters per 1 liter of ZEOvit®). We strongly recommend not exceeding the maximum flow rate of 100 gph per 1 liter of ZEOvit®, which could ndoubtedly have a negative impact. High water flow through the edia in already stocked tanks, especially during the start up of this system, has shown to cause slow tissue loss in SPS corals. We recommend a lower flow rate through the media during the first few weeks of introduction of this method to a tank already stocked with corals. The effectiveness of this system in reducing nutrients could result in changes that are to abrupt when higher flow rates are used. However, corals need time to “adapt” to these new nutrient conditions. Tom R
|
|
#8
12-13-2007, 01:40 AM
|
|||||
|
|||||
|
Thanks everyone. I'll post its performance or any modes. Any of you that are serious about getting one I would help you out after the holidays, just shot me a PM. I enjoy doing things like that.
__________________
Mike 150g reef, 55g sump, T5's, Vertech 200A, Profilux III - German made is highly over rated, should just say Gerpan made. Reefkeeper - individual obsessed with placing disturbing amounts of electricity and seawater in close proximity for the purpose of maintaining live coral reef organisms.
|
|
#9
12-13-2007, 01:43 AM
|
|||||
|
|||||
|
Thanks Tom, yes I,m going to use a bout 1L at about 100 gph and have it on a timer for 3 hrs on and 3 off for the first couple of weeks.
Quote:
__________________
Mike 150g reef, 55g sump, T5's, Vertech 200A, Profilux III - German made is highly over rated, should just say Gerpan made. Reefkeeper - individual obsessed with placing disturbing amounts of electricity and seawater in close proximity for the purpose of maintaining live coral reef organisms.
|
|
#10
12-13-2007, 08:08 PM
|
||||
|
||||
|
Great job on the reactor, do you mind if I copy your design for my own tank.
What is your high of your reactor. What size of tank you have. Thanks
__________________
120 G sps reef, looking to build bigger. 
|
Hybrid Mode
