|
|
|
|
|
#1
12-03-2007, 07:18 AM
|
||||
|
||||
make sure the beckett is clean and your return valve is open enough
__________________
aga 180g dual overflow 77g sump, mak 4 return, dart pump for closed loop 3 250w se 15,000k mh, 4 80w t5 250 vertex skimmer,3l vertex zeo reactor, marine tech cal reactor.regal,powder brown and yellow tangs, chromis eyelash blennie blue mandran, slowly filling with SPS 
|
|
#3
12-03-2007, 12:16 PM
|
||||
|
||||
|
Quote:
Last edited by kari; 12-03-2007 at 12:18 PM.
|
|
#4
12-03-2007, 01:55 PM
|
|||||
|
|||||
|
i've got a pm bullet 2 and never have had that problem. i'd disassemble the injector to see that it's clean and reassemble according to the instructions. check where the injector sits in the base to ensure its clear. does your injector have a control for volume of air? you should be able to have the skimmer operational for water flow without any air. then slowly try to turn on the air.
good luck
__________________
tanks: 120g w/starphire front, pm bullet 2 skimmer, yellow tang, emperor angel, niger trigger, spotted hawkfish, blue tang, flame angel and 120lbs lr
|
|
#5
12-03-2007, 02:22 PM
|
|||||
|
|||||
|
I would take the beckett out make sure it isn't plugged up at all (clean it up) then try again making sure your valves are all open.
Steve
__________________
 *everything said above is just my opinion, and may or may not reflect the views of this BBS, its Operators, and its Members. If cornered on any “opinion” I post I will totally deny having ever said this in a Court of Law…Unless I am the right one*Some strive to be perfect.... I just strive.
|
|
#6
12-03-2007, 03:53 PM
|
|||||
|
|||||
|
Thanks for all the suggestions. I tried most of them now. Still nothing...
Same thing keeps happening. Im so confused.
|
|
#7
12-03-2007, 04:32 PM
|
|||||
|
|||||
|
Did you put the beckett back in with the correct orientation?
__________________
32"x32"x20" Cube-ish tank
|
|
#8
12-03-2007, 04:40 PM
|
|||||
|
|||||
|
Well this started happening before I had ever touched the beckett at all. It worked fine when I hooked it all up for the first time. Then I turned it off and took off the air intake valve which is just a threaded fitting. Put that back on and started the pump and water came spraying out. So nothing to do with the beckett I dont think. I did take the beckett apart later and as far as I know it was put back the same.
|
Hybrid Mode
