aquasafe RO/DI problems

rattler · #1 11-27-2007, 05:03 AM

one more request could somebody please post a picture or diagram of the valve with the 2 inlets and 2 outputs. When I reversed the input lines it seems to be functioning properly. will need to wait for some water to be produced to see if the TDS is correct.

Cheers!
Geoff

Jason McK · #2 11-27-2007, 05:08 AM

That is a solenoid that will activate and shut off water production if a float valve is installed. All you need to do to test if it is working is plug the good effluent and it should stop the water flow

J

rattler · #3 11-27-2007, 05:22 AM

Jason thank you for the help

Geoff

mark · #4 11-27-2007, 01:53 PM

Left blue - in DI
Left White - RO (left side)
Rgt Blue - RO (rgt side top)
Rgt White - fr pre-filters
(Yellow line just runs under PCV)

rattler · #5 11-28-2007, 04:19 AM

Thank you to everyone!!
After testing the water out the TDS was still in excess of 150 ( Grrrr!!) found the lines from the output of the ro filter were reversed and the waste water was going through the di to the drum. Having fixed this now the TDS is now under 100 and dropping. I will let this work for a while (overnight ) and flush the membrane and see where I stand.

Cheers!!
Geoff