|
|
|
|
|
#1
10-06-2007, 03:36 AM
|
||||
|
||||
Not sure if this is the issue, but there's a problem with a bunch of different batches of Salifert ALK tests giving artificially high results. There's a thread in the Salifert forum on RC that lists the affected lots.
|
|
#2
10-06-2007, 05:53 AM
|
|||||
|
|||||
|
reply
I use OPP and find that my ALK levels are too low, around 7 dkh, at least with this bucket. Mg is very high though which might affect the reading for the other levels. I usually dose ALK anyway so I've never worried about it.
__________________
THE BARQUARIUM: 55 gallon cube - 50 lbs LR - ASM G3 skimmer - 30 Gallon sump - 22 Gallon refugium / frag tank - 4x 24 watt HO T5's - Mag 9.5 return - Pin Point PH monitor - 400 watt XM 20K MH in Lumenarc reflector - Dual stage GFO/NO3 media reactor - 6 stage RODI auto top up -Wavemaster Pro running 3 Koralia 2's. Fully stocked with fish, corals and usually some fine scotch http://www.canreef.com/vbulletin/showthread.php?t=55041
|
|
#3
10-06-2007, 06:58 AM
|
|||||
|
|||||
|
It seems that no salt is perfect right? You will always have to dose for something. So far with the OPP the mag and cal is higher than IO and it seems to mix better. If all I gotta do is dose for Alk that's not so bad. That's just my opinion so far. But I haven't been through that many buckets of salt yet.
__________________
|
Hybrid Mode
