making a stand

[Static]

Originally Posted by super7

Would MIG wleding work ok to put the stand together or should i use a differnet form. The stand is for a 65 gallon tank and beside it is going to be a fiberglass tank I am making it is 18x18 and 24 inches tall. so there is roughly 90 gallons of water ontop of the stand.

Water is approximately 10 lbs per gallon so 90 gallons of water will be about 900 lbs, if that's any interest to you....

Any welding process, if done properly will be adequate to hold your stand together. I personally use MIG, it's fast and relatively easy. Just make sure you're confident in what you're doing before you put 900 lbs of water on top of it.

Good luck and have fun