|
|
|
|
|
#1
08-29-2007, 06:53 AM
|
||||
|
||||
Amp,
thank you for your feedback. After the update ProfiLux restores the factory settings. This is normal and no problem. After that you have to load the sensor data and the settings you saved before the update back to ProfiLux. A warning occurs before you load the settings back to ProfiLux because the firmware changed - that can be ignored. I updated here all ProfiLux without any problem. 
|
|
#2
08-29-2007, 04:26 PM
|
||||
|
||||
|
Quote:
Yes that would be correct, I was able to re establish a connection after stopping the profilux, then re booting, For some odd reason the IP search was seeing the unit but refused to connect. After a hard restart it connected with no problems, I was always one to beta programs, always kept an original on my Lap top just in case  Thanks for all your hard work on a very cost effective unit. Tony_P
|
|
#3
09-30-2007, 08:32 AM
|
||||
|
||||
|
I am not able to connect via WLAN to my Profilux. I just upgraded software/firmware to 3.04, the network sees it, the Control software sees it ... but it won't complete the connection. I have rebooted both my PC and the Profilux Comp and it isn't coming online.
Any ideas? Regards,
|
|
#4
09-30-2007, 01:09 PM
|
|||||
|
|||||
|
Are you running VISTA by any chance?
|
|
#5
09-30-2007, 06:39 PM
|
|||||
|
|||||
|
good luck getting WLAN to work. its a major pain in the @#$
|
|
#6
09-30-2007, 07:12 PM
|
|||||
|
|||||
|
This pain in the @@@ is about to end, a birdie tels me V5 will have plug and play capabilites, mainly due to Vista and its hidden securities!!
maybe Matthias can grace us with a bit more info on here after the weekend
|
|
#7
09-30-2007, 07:24 PM
|
||||
|
||||
|
no .... but here is the story...
I got profilux months ago and hooked up wireless from my XP desktop no problem at all... then I bought a laptop with Visa... tried to connect ... no problem! Awesome.... BUT suddenly I came home one day and none of my machines had internet and I couldn't connect to the profilux. I checked router and all of the security was put on (I have it off).... so I redid all that. I think Vista may have reconfigured the router? Anyway.... Still using 3.02 at this time, I put everything back to normal, I made an ad hoc connection and redid everything. Again I could get in to the WLAN card and make changes no problem. The control software would not connect though. Port 10001..... So I decided to upgrade to the new software and new firmware. No problem. Now the control software see's the controller but won't make the connection... Please advise,
|
Hybrid Mode
