|
|
|
#12
07-25-2007, 03:15 PM
|
||||
|
||||
koralia
The smaller version should be available Mid September and should be dirt cheap as far as I have found out.
As well, on the seio controller, you can run quite a few more koralias that you could Seio's due to the extrememly low wattage. I am currently running 4 koralia 4's on the seio wavemaker with no problems for about 3 months. Nate Last edited by Nate; 07-25-2007 at 05:00 PM. |
|
#13
07-25-2007, 03:59 PM
|
|||||
|
|||||
|
Actually, the Nanostream 6025 is rated at approximately 660gph. The 6045, however, is rated at 1189gph.
__________________
~Drew 10G Nano * 10G Sump * Deltec MCE 600 Skimmer * JBL Viper 150w MH * Zeovit * Vortech MP40W Millions long for immortality who do not know what to do with themselves on a rainy Sunday afternoon. ~S. Ertz  |
|
#14
07-25-2007, 04:19 PM
|
||||
|
||||
|
Oops, my bad.
Was going with the first link on google: http://www.jlaquatics.com/phpstore/s..._ID=tz-tsn6025 "The Turbelle nanostream combines aesthetics and function. This innovative circulation pumps sets new records. At a diameter of only 2.7", it enables a waterflow of up to 1189gph at an energy consumption of only 8 watts."
__________________
This and that. |
|
#15
07-25-2007, 05:20 PM
|
||||
|
||||
|
i have the #4, it replaced 2 nano streams for me... my nano's were noisey and unreliable... the #4, is AWSOME in my 50gal tank, tons of flow and completly silent... not quite as small as the nano's but better overall i'd say.
__________________
Sean |
|
#16
07-26-2007, 06:54 PM
|
|||||
|
|||||
|
Quote:
Thanks Tom. |
|
#17
07-26-2007, 07:11 PM
|
||||
|
||||
|
Yup, you should have no problems running Koralia's on SEIO controllers. Lots of people in the States have done so ever since these things hit the market with no ill effect.
__________________
This and that. |
|
#18
07-26-2007, 07:20 PM
|
|||||
|
|||||
|
So do the controllers power them right off, or does it bring it down to where the impeller is hardly spinning. I ask becuase I have started to have a couple issues with my Korlia 4's when I turn off the flow for feeding when I turn the back on the don't always fire up right away, they either need a tap or to cycle to power a couple times to get them started. I had this issue with Seios and I hated them.
__________________
- Greg 90G : Light - Tek 6xT5 | Skim - EuroReef RS135 | Flow - 2xVortech MP40W | Control - Reef Keeper 2 |
|
#19
07-26-2007, 07:53 PM
|
|||||
|
|||||
|
They power them down, to my understanding.
__________________
~Drew 10G Nano * 10G Sump * Deltec MCE 600 Skimmer * JBL Viper 150w MH * Zeovit * Vortech MP40W Millions long for immortality who do not know what to do with themselves on a rainy Sunday afternoon. ~S. Ertz |
Linear Mode
