Profilux II plus aquarium controller

[Jukka]

Originally Posted by Jukka

...results in max couple of minutes long pulse...

OK, the pulse lenght means maximum time for the pulse. I need to read better (and increase hysteresis) .

[Matthias Gross]

@niloc: at the moment only 2 pumps (or groups) can be controlled independently. I am not sure how to programm a mode for more than 2 pumps. Now it is easy - 2 pumps, one ebb, other flood and vv. But how can i program 3 or more pumps?
@jukka: i must be honest with you - firmware 3.01 has a little bug regarding the pulse/pause mode. Durations longer than 256s (damned BYTES and WORDS...) can't be calculated. From 3.02 this function is OK.

[Ginzo]

Thanks Matthias,

Can we expect at some point an update to the firmware that will enable us to send an email when an alarm goes off..or an SMS ?

Regards,
Ginzo

[Ginzo]

Now if somebody could only explain to me the "probe holder pieces" that came with my Profilux..I'm a little baffled at how to set them up ?

[big blue]

Originally Posted by Ginzo

Now if somebody could only explain to me the "probe holder pieces" that came with my Profilux..I'm a little baffled at how to set them up ?

You can find the answer here http://www.aqua-it.de/phpBB2/viewtopic.php?t=414

[Ginzo]

whoa ! would have taken me forever to figure that out !

Thanks for the post !

Here's the picture in question:

[albert_dao]

Out of curiousity, is there a different number of upgradable slots between the Basic package and the Complete package? If so, how many slots?

[Matthias Gross]

Ginzo,

it is allready possible to send an email in the event of an alarm.
I wrote instructions for that, till now only in German. I will let you know when the English instructions are available. Coming soon.

[Ginzo]

ok great Matthias !

Please let us know how to send an email in the case of an alarm.

I haven't seen any instruction in the manual or any thing relating to an email in the controller Software.

Regards,
Chris

[Ginzo]

Here's how to setup the float switch:



Here's how I setup mine in my overflow, to prevent an overflow
If the water get's to high, it will activate the float switch and turn off the return pump for a period of 10 seconds.



Matthias, you should include the first picture in the Profilux Manual, I was surprised it wasn't included.