![]() |
|
View Poll Results: How long do you age your new water? | |||
a week or more |
![]() ![]() ![]() ![]() |
23 | 12.92% |
5 days |
![]() ![]() ![]() ![]() |
3 | 1.69% |
4 days |
![]() ![]() ![]() ![]() |
5 | 2.81% |
3 days |
![]() ![]() ![]() ![]() |
9 | 5.06% |
2 days |
![]() ![]() ![]() ![]() |
23 | 12.92% |
24 hours |
![]() ![]() ![]() ![]() |
54 | 30.34% |
a few hours |
![]() ![]() ![]() ![]() |
20 | 11.24% |
as soon as it's dissolved!! |
![]() ![]() ![]() ![]() |
41 | 23.03% |
Voters: 178. You may not vote on this poll |
![]() |
|
Thread Tools | Display Modes |
#1
|
|||||
|
|||||
![]() Just curious. Usually two or three days for me.
Last edited by GrimReefer; 03-01-2007 at 02:03 AM. |
#2
|
|||||
|
|||||
![]() I usually make up new stuff as soon as I finish a water change, that way I always have fresh salt water on hand if I need it
![]() |
#3
|
|||||
|
|||||
![]() i am the same as marie so my water is going for at least 5 to 7 days before i use it. but if i do need to do a change again soon i wait at least 2 days only to make sure salinity is good and temp is good.
|
#4
|
|||||
|
|||||
![]() I have the water ready to go but don't put a heater/powerhead combo in it until the night before and then add salt right before I do a water change. That way I can use it for my "auto" top off if needed
![]()
__________________
Christy's Reef Blog My 180 Build Every electronic component is shipped with smoke stored deep inside.... only a real genius can find a way to set it free. |
#5
|
|||||
|
|||||
![]() A day sometimes more with a PH in the ro/di water, add salt, heater another PH then usually get the change a day or two later.
|
#6
|
||||
|
||||
![]() I don't wait at all, I don't heat it at all, I change 10% (12 gallons) at a time in a 120 gallon tank, the IO salt mixes with a few stirs of a stirring rod, pour it right into the tank, the temperature drops a couple of degrees, no one seems to mind. I would be more careful if I was doing larger water changes.
|
#7
|
|||||
|
|||||
![]() Anywhere from 18 to 30 hours, depending on when I mix the day before and when I do the change the day of. BTW, since using RO/DI water I have noticed a HUGE reduction in the brown ring left behind on the tote.
Cheers,
__________________
Mark. |
#8
|
||||
|
||||
![]() I mix up a new batch as soon as Im done doing my water change, so mine sits for a week.
RO water makes a huge difference. Try using it when you make Icecubes.. amazing how clear they are and they pop right out of the tray. ![]() |
#9
|
|||||
|
|||||
![]() As soon as the bin is empty I refill it as it has 2 powerheads, heater etc so I always have some handy in case of trouble and I can perform a waterchange whenever I want to....(we also have 7 tanks in the house so water changes are a constant!!!
![]()
__________________
No act of kindness, no matter how small, is ever wasted. Sarah |
#10
|
|||||
|
|||||
![]() Ditto. Leaving the saltwater warm too long always reminds me.
__________________
http://www.canreef.com/ftotm/sept05/index.php |