Canreef Aquatics Bulletin Board  

Go Back   Canreef Aquatics Bulletin Board > General > Reef

Reply
 
Thread Tools Display Modes
  #1  
Old 02-13-2007, 05:09 AM
marie's Avatar
marie marie is offline
Member
 
Join Date: Mar 2002
Location: powell river
Posts: 3,029
marie is on a distinguished road
Default

When I've moved my tanks, I've put the water into garbage bags (stops the water from sloshing out of the can)and inside trash cans. The rock went into separate tubs and covered with damp tea towells to keep from drying out and the animals went into plastic bags and placed in a styrofoam cooler.

The only thing of real concern is if there is sand, if it has a deep sand bed you may want to replace it with new stuff. If the sand isn't very deep you could leave it in the tank and transport as is, providing it doesn't make the tank too heavy
__________________
~Marie~

300g tank
http://www.canreef.com/vbulletin/showthread.php?t=86252
Reply With Quote
  #2  
Old 02-13-2007, 05:21 AM
fishbait's Avatar
fishbait fishbait is offline
Junior Member
 
Join Date: Jan 2007
Location: Abbotsford, BC
Posts: 20
fishbait is on a distinguished road
Default

again - thanks for the input... but a further question about the sand.
How much is "deep" (>6inches)... and why start new with this much?

Also, I 've read different oppinions about how fast to add the LR after the move... one author says to go slow and add the sand after a few days and the rock in a week, another basically says... "go for it"...(same day once the water is in and the temp/PH are within limits.
If the LR transports well, is there any way to really screw it up by adding it to the tank too early?
Reply With Quote
  #3  
Old 02-13-2007, 05:31 AM
marie's Avatar
marie marie is offline
Member
 
Join Date: Mar 2002
Location: powell river
Posts: 3,029
marie is on a distinguished road
Default

I added everything back in fairly quickly after the tank is put back together. Put the rock in, then the water. Hook up the powerheads and heater and let it run for a little while before adding the animals ( you should check ammonia levels before adding them just in case).

Tha sand bed, if it is deep 4" or more can cause big problems if disturbed releasing nasties into the water and if it is that deep, chances are it will be way to heavy to carry the tank if the sand is left in there.

You don't have to add any sand back in if you don't want to and the tank may already be bare bottom, saving you a whole bunch of trouble
__________________
~Marie~

300g tank
http://www.canreef.com/vbulletin/showthread.php?t=86252
Reply With Quote
  #4  
Old 02-13-2007, 05:26 PM
klm
Guest
 
Posts: n/a
Default

I moved an established tank of this size about 8 mos ago (in the summer)
The trick with the deep sand bed is to remove it and put it in a pail with holes in the bottom, so it moves wet, but not standing in water. Before removing it from the tank, remove all the water you want to save ( I tried to save most of it) and then stir up the sand bed really well, it will stink and be
black and murky, now siphon off the sludge as much as you can and get rid of it. Now load up the sand into the pail with the drainage holes, and its ready to add back to the new setup. I didn't get any cycling after moving, and lost no livestock. I did do fairly frequent water changes for the first while
and tested water alot. The live rock I just transported in styrofoam boxed with wet newpaper over top. I guess the big concern will be keeping the temperature warm while transporting. Good luck and hope this helps. Karen
Reply With Quote
  #5  
Old 02-13-2007, 06:42 PM
danny zubot's Avatar
danny zubot danny zubot is offline
Member
 
Join Date: Apr 2004
Location: Castlegar BC
Posts: 3,469
danny zubot is on a distinguished road
Default reply

I just moved my 65 gallon system a couple of months ago. Logistically you want to make sure you have plenty of buckets or water tight containers for everything. I used 5 gallon salt buckets for everything, fish, live rock, corals and water. I filled each bucket with a few rocks then added water. I only filled them 3/4 to the top so that they weren't too heavy. Fish went into a few different buckets, and corals in a few other buckets, all with lids. I managed to salvage about 65% of my original water this way.

As far as the sand bed goes, I've always cleaned mine befor re-using it. There are a ton of nasties laying at the bottom of a sand bed that will surely spike the levels once the system is setup. I used tap water, and rinsed it until the water was no longer brown.

I think the most important tip in moving a tank is to make sure that you have plenty of salt water waiting at your place for when you start to set up the system. You never really know how much water you will loose. You may find that some of the water is too dirty by the time you get home to put back into the tank. I would recommend having at least 50 gallons for the tank you are buying.

Good luck, and welcome to Canreef!
__________________
THE BARQUARIUM:
55 gallon cube - 50 lbs LR - ASM G3 skimmer - 30 Gallon sump - 22 Gallon refugium / frag tank - 4x 24 watt HO T5's - Mag 9.5 return - Pin Point PH monitor - 400 watt XM 20K MH in Lumenarc reflector - Dual stage GFO/NO3 media reactor - 6 stage RODI auto top up -Wavemaster Pro running 3 Koralia 2's.

Fully stocked with fish, corals and usually some fine scotch
http://www.canreef.com/vbulletin/showthread.php?t=55041
Reply With Quote
  #6  
Old 02-14-2007, 03:14 AM
fishbait's Avatar
fishbait fishbait is offline
Junior Member
 
Join Date: Jan 2007
Location: Abbotsford, BC
Posts: 20
fishbait is on a distinguished road
Default

Thanks guys! We went to see the tank today and it looks great, so we'll be putting your tips to use shortly!

One other question though: if we have some live rock in the sump, how important is it to have a light running down there? Does LR need a solid dose of light each day, or can it live in the dark?
Reply With Quote
  #7  
Old 02-14-2007, 03:35 AM
marie's Avatar
marie marie is offline
Member
 
Join Date: Mar 2002
Location: powell river
Posts: 3,029
marie is on a distinguished road
Default

Live rock doesn't need light you will just get sponges and things growing on it instead of algae
__________________
~Marie~

300g tank
http://www.canreef.com/vbulletin/showthread.php?t=86252
Reply With Quote
Reply


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT. The time now is 06:18 AM.


Powered by vBulletin® Version 3.7.3
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.