How many use both - Ca & Kalk reactors

[KrazyKuch]

I use both and i just run my topoff right threw the Kalk Reactor so that when I need water replaced it's replaced with Kalkwater

[Delphinus]

I used to do that too but I grew tired of cleaning out my float valve every few months. Although on the other hand it was far less problematic than trying to have a slow drip rate instead. What was happening was that as my RO/DI barrell emptied, it has less head pressure pushing the water through the lines and thus the drip rate would slow down more and more until it was time to refill the barrell.

Originally Posted by littlesilvermax

I use both just to keep up!

FWIW I have a needle valve feeding my kalk reactor (from my RO/DI unit resevoir) and it works for about 5 to 6 months before my drip rate changes.

Littlesilvermax, how much height differencial do you have? 5 to 6 months with a steady rate is incredible. Or how often if your RO/DI reservoir being refilled? Maybe that's the difference, you're keeping yours full whereas I let mine get close to empty before refilling (mine is a 50g resevoir and I only need to refill it every two weeks or so).

[littlesilvermax]

Originally Posted by Delphinus

Littlesilvermax, how much height differencial do you have? 5 to 6 months with a steady rate is incredible. Or how often if your RO/DI reservoir being refilled? Maybe that's the difference, you're keeping yours full whereas I let mine get close to empty before refilling (mine is a 50g resevoir and I only need to refill it every two weeks or so).

I run a switch on my RO system (I know not ideal due to TDS creep, but I have DI too, but it is for the whole house as well) so the pressure (I have a gauge) goes from a low of 30psi to a high of 55 psi.

It fluctuates a little due to the pressure swings, but it is less then 15% I would say.

[Tangman]

Originally Posted by KrazyKuch

I use both and i just run my topoff right threw the Kalk Reactor so that when I need water replaced it's replaced with Kalkwater

ME too ! ME too!

[KrazyKuch]

I have a 12 VDC float valve that controls a power head, which pumps the water to my Kalk Reactor so I have nothing to clean other then the reactor every once and a while

[Tangman]

Originally Posted by KrazyKuch

I have a 12 VDC float valve that controls a power head, which pumps the water to my Kalk Reactor so I have nothing to clean other then the reactor every once and a while

Again Me Too !
my float controls a 12 volt relay which controls a 12 volt tunzes pump

[andestang]

.......so both just to keep up with the calcium, not to help stabilize PH/Alk levels also ?

[StirCrazy]

Originally Posted by andestang

.......so both just to keep up with the calcium, not to help stabilize PH/Alk levels also ?

its kind of a mixed bag, while a Ca reactor can maintain Ca, it is better at maintaining alkalinity. The Kalk reactor on the other hand is better at maintaining Ca than alk. also the kalk reactor will help to ofsett the lowering of PH by the Ca reactor.

I also ran my kalk between the float valve and the top off resavoir, but it would take 6 months befor I absolutly had to clean the float valve and that just took a couple minuits to knock off the build up.

Steve

[rickjames]

I run both just to keep up with Ca/Alk as well, since my Ca reactor wasn't cutting it.