|
|
|
|
|
#1
02-06-2007, 12:04 AM
|
|||||
|
|||||
You could repair it with a patch as you suggested,you would need to trim the old silicone down for a tight fit.Use lots of silicone.Should work but a safer bet would be to replace the bottom glass.
Almost forgot,if you do patch it,leave the old broken glass inplace and spread silicone over the whole thing.
__________________
No matter how hard you try, you can't baptise cats. Last edited by Quagmire; 02-06-2007 at 12:07 AM. Reason: too many woman not enough time 
|
|
#2
02-06-2007, 02:59 AM
|
||||
|
||||
|
Glass repair
I had a 33 gallon that was repaired as has been described - I used it for 6 years as a freshwater tank and then a year as a saltwater tank and had no problems.
|
|
#3
02-08-2007, 01:55 AM
|
||||
|
||||
|
If you do decide to try this repair I would have the tank sit on foam for the rest of it's life. Insulating foam like the blue or pink stuff or even the white stuff, just to make the weight of the tank spread out a bit better.
Doug
|
|
#4
02-08-2007, 05:07 AM
|
||||
|
||||
|
It's edge to edge so it won't spread. If you strip off as much of the old silicone as you can you should be able to add a patch that joins to the sides and on top of the bottom. Do spread a thin layer like BCOrchid suggests. I did something similar in my overflow, has been fine for about a year.
|
Hybrid Mode
