recommend a pump??

[mark]

There's lots of pumps that can handle a 10' head, chk this link and open the more info to get the curves. Can also look at RC's head loss calculator.

Don't forget to look through the Buy and Sell section, some good ones there such as http://216.187.96.54/vbulletin/showthread.php?t=27854

[fishface]

Originally Posted by mark

There's lots of pumps that can handle a 10' head, chk this link and open the more info to get the curves. Can also look at RC's head loss calculator.

Don't forget to look through the Buy and Sell section, some good ones there such as http://216.187.96.54/vbulletin/showthread.php?t=27854

hey thanks for that. you don't deliver do ya? cause i'd like to take that off yer hands

[fishface]

so the headloss calculator's minimum diameter output is 3/4" smallest. is it completely unreasonable to make that work with a 1/4" output line...even with a larger pump?

[KrazyKuch]

No cause of the pressure you would create on the pump

[fishface]

Originally Posted by KrazyKuch

No cause of the pressure you would create on the pump

dang! well thanks anyhow. i suppose i'm just gonna have to make bigger holes in the floor and wall.

[mr_alberta]

How is your current ATO setup?

Also, you don't need a monsterous pump, just one with a high pressure rating...unless you want the water to fill up really fast. Check out something along the lines of Iwaki 40RLT or an Iwaki 20RLZT to get an idea. You can get either of those pumps for a pretty good price from time to time on CanReef.

But, if you want a big pump, I know someone who has an Iwaki 100RLT for sale...

[fishface]

Originally Posted by mr_alberta

How is your current ATO setup?

Also, you don't need a monsterous pump, just one with a high pressure rating...unless you want the water to fill up really fast. Check out something along the lines of Iwaki 40RLT or an Iwaki 20RLZT to get an idea. You can get either of those pumps for a pretty good price from time to time on CanReef.

But, if you want a big pump, I know someone who has an Iwaki 100RLT for sale...

RO/DI and FW resevior are downstairs in the garage below my tank and sump. i've got an osmolator pump in the resevoir pumping to my sump (about 3' vertical climb) above, resevoir is almost ceiling height in garage. all run through 1/4" tubing. preferably i'd like to "T" off the feed to the sump and put a valve in so i could feed my change water through the same ATO line.

so no, it doesn't need to be HUGE gallonage per hour but something with good pressure i suppose. needs to go from my garage floor, 1 floor up, say 10'-12" in vertical height.

do the iwaki's have high pressure ratings?