Profilux II plus aquarium controller

[support@proline]

Hay Doug
Good to hear from you.
The 6d & 4d can't be chained however ,however talk to mike & I am sure he can aarange something for you
The propeller breeze control is in stock & mike should have a couple in stock my friend.
As for wavy sea I will ask the manufacturer & let you know.
Have fun shavelling my friend ,I did some earlier,Damn it's cold

[niloc16]

again i came home and found my one tunze off again. i am not using the y adapter i have each pump connected to its own port, when i swapped ports the problem swaps pumps, i have triple checked my programming and all seems good. again, is turning the pump off part of the random current generator?

[SuperFudge]

Colin,

Tommorow afternoon i will take the tunzes off the other controller and try it on the profilux.

Ill let you know what happens.

Marc.

[niloc16]

thanks marc. its happened two days in a row now

[Matthias Gross]

Hi niloc,

Did you read my last post about tunze?
Please give me detailled information about your configuration regarding the pumps. Where are they connected, what cables do you use?
After that i will tell you how to do the proper settings.

[niloc16]

they are using the tunze 1 and tunze 2 cables, one is installed in L1-L2 and the other installed in L3-L4, 1-10v port 1 is set to current pump1 and 1-10v port 3 is set to current pump2, random flow, min volt4 and max volt 10, nocturnal decrease to 30%, max flow of both pumps 100% and min flow of both pumps 40%. wave 30s, min duration 30min max duration 1hr 30min (unsure exactly the use of this setting but that is what it is set ). i believe that is all the settings they are set to. let me know if i missed something that you need to know

[Matthias Gross]

niloc16,

i think i found the mistake.
Cable ProfiLuxTunze1 uses L1 (or L3 when used in L3L4), cable ProfiLuxTunze2 uses L2 (or L4 when used in L3L4). So we have two different Tunze-cables, they can be connected to one port (eg L1L2) using an Y-adapter, then L3L4 would be free for other purposes.
That means in your case: 1-10V port 1 (=L1) and 1-10V port 4(=L4!) should have function pump 1 and pump 2! (Assuming you connected Tunze1 to L1L2 and Tunze2 to L3L4, otherwise we talk about the 1-10V-ports 2 and 3).
So please configure 1-10V-interface 4 - then it should run.

[niloc16]

thanks matthias, this will probably drive you nuts, but with the cables out of the bag is there markings one them to determine which one is tunze cable1 and tunze cable 2? now that i have been swapping them to troubleshoot i dont which is which.

[Matthias Gross]

Then you must test it out.
Eg. in the following manner:
Plug in first cable: L1L2 to tunze
Set function of 1-10V-interface1 to dimm channel 1
Set function of 1-10V-interface2 to dimm channel 2
(the voltages can remanin)
Go to menu "manual light intensity"
switch off auto - yes
Dimm up and down D1 and D2
Reacts the pump on D1 or D2? Then you know it is Tunze1 or Tunze2
(The other cable is then also clear)
Don't forget to set again the 1-10V interfaces you need to pump1/2