Sulfur denitrator experiment

[AndyL]

Tony,

Ok, working off some reading I've done on this topic - not first hand (I prefer coil based denitrators myself). Sounds like your through-put is way too fast, crank it WAY down until you start seeing effluent output with 0 nitrite / 0 nitrate (or get stunk outta the house - that'd indicate way too slow). Once you get that 0/0 effluent then start bringing up the drip rate slowly.

Definitely check that mag pump you're using for recirc... Although that kicks your cycle back to day 1 again (introduction of too much o2 - supposed to be a low o2 environment), if it's not working up to snuff - the lack of recirc could be causing some problems.

since i'll never find the link again - good rc thread: http://reefcentral.com/forums/showth...hreadid=752497

[Delphinus]

Oh yeah, one thing is, the effluent has never had any kind of sulfurous scent to it whatsoever. Isn't that odd? I think it has be indicating something's not right here.

Yeah, maybe 1 to 2 drops per second is too fast for the volume.

I'm firmly convinced that this is not working and not going to work given an indefinite amount of time -- something has to change on it first.

[Skimmerking]

Tony do you have a pic of the reactor I would like to look at it for a sec..

[Delphinus]

Santa brought me Vol3 T.R.A. Within 5 minutes of reading it I found about 4 things I'm doing wrong with this arrangement and that's only reading a few paragraphs of the sulfur section, by the time I'm done reading it all I could find out a few more things that aren't right with how I'm trying this.

Soooo .. I guess this calls for a "do-over". I'll elaborate on the mistakes of this setup later (stepping out for a while now).

[andresont]

Sulfur denitrator experiment still alive !

[andresont]

Originally Posted by asmodeus

Tony do you have a pic of the reactor I would like to look at it for a sec..

http://www.canreef.com/vbulletin/showthread.php?t=28791

you can try first page of this tread for the pictures..

[Psyire]

I'm interested to hear what you think you've done wrong.

Not very encouraging results though... but perhaps there is a reason(s) that we'll find out soon.

I'm getting quite close to starting my own experiment, with any luck it will be late next week.

[seashells]

If you feel the nitrate readings are off then I would ask some other reefers to test your water. I had a salifert test kit and got off the wall readings. I compared it to a friends test kit and also the store where I bought it. I found after comparing I had to divide my readings by 2. So its possible your kit is inaccurate.

Doug

[Delphinus]

So, bearing in mind I haven't read the section in detail yet, only scanned it, these are the things that caught my eye:

- recommend upflow instead of downflow to avoid compaction
- recommend flow control valve on input not output to avoid pressurizing the unit
- recommend media volume 1% of total tank volume
- something about the reactor height to diameter ratio should be something like 5:1 (I'll have to read more about that one)

My main thinking here is that the flow-through is too high, and the recirc is not enough. I don't know about switching to 1% tank volume as that will need a different reactor, same with changing the height/diameter ratio (actually mine may already be close to that anyhow, give or take). The main thing I'm thinking is switching the flow control valve to the input, leaving the output wide open; changing the flow direction to upflow; potentially scrapping the feed pump (since need to slooooowwww it down even more), and upping the recirc pump from a mag2 to a mag7 or mag9.