|
|
|
|
|
#1
11-21-2006, 04:47 PM
|
|||||
|
|||||
Thanks for the info. I'm looking at your photos and it's helping me plan out the "corner viewing" aspect I was hoping to acheive with my 280g as well. I wasn't sure if I was going to be supporting the wall framing to the ceiling above, or what. I might need to consult a builder, I'm not sure what's kosher for suspending things on the floor above. I like how you've solved that with the wall flush to the right-hand side tank wall.
A couple more questions.. what's your floor, is it concrete? If so how is the stand attached to the floor at the bottom? To make the stand open at the back (where the sump is sitting) without a bottom cross bar member (or whatever it's called) did you have to put any diagonal bracing, or additional posts under the middle of the tank or anything like that? Thanks once again for the info. Very helpful!!
__________________
-- Tony My next hobby will be flooding my basement while repeatedly banging my head against a brick wall and tearing up $100 bills. Whee! 
|
|
#2
11-21-2006, 05:21 PM
|
|||||
|
|||||
|
Quote:
The stand has 2x6's joists spanning the 4 foot width. These joists run every foot. The vertical supports are only 2x4's. Where I was not able to have a vertical support every foot (like where it spans the sumps), I doubled the 2x4 on either side. There are no centre posts, or diagonal braces...the stand is completely open underneath. It's basically the same way that you would build a small house. You build 2x4 wall sections...then you build a floor out of 2x6's on edge and screw it onto the wall sections. That construction is not stable until you screw plywood to the faces. Once the 3/4" plywood was screwed to the front, left, right and top sides it is rock solid. It would be MUCH less stable if I had wanted doors on the front and side. Maybe I'll post some detail shots of the stand for you.
|
Hybrid Mode
