input on vortech pumps

Jaws · #1 10-20-2006, 05:56 AM

Recently I've been experiencing an internal rattle or knocking noise coming from inside the motor housing. It's really noticeable when it's on high. Anyone else experience this?

Tarolisol · #2 10-20-2006, 06:15 AM

Mine have ran perfect since i bought them a couple weeks ago, havent touched them since.

support@proline · #3 10-20-2006, 06:40 AM

Jason
Please contact Ecotech ,the rattling sound is not normal,Please keep me posted of the outcome

niloc16 · #4 10-20-2006, 07:07 AM

if i listen closely to the motor i can hear a slight ticking as well kind of like a light rattle

support@proline · #5 10-20-2006, 07:19 AM

Colin you have the new generation ,I doubt there is any probelm with your pumps ,you are hearing the moving components ,which is normal.
In case of Jason's pump I know he got the old generation & he already had a problem with it that's why I suggested to contact ECOTECH.

niloc16 · #6 10-20-2006, 07:37 AM

i figured it was normal but i was a little concerned when i seen jasons post. thanks for the response though

Jaws · #7 10-20-2006, 03:19 PM

Quote:

Originally Posted by support@proline

Jason
Please contact Ecotech ,the rattling sound is not normal,Please keep me posted of the outcome

Thanks. I'll do it today. In the meantime do you think it's ok to still run the pump? I can't really afford to lose that much flow for how long it would take to send my pump back and wait to get it fixed.

I checked the pump today and it seemed fine, even on full blast. I noticed that the propellor housing had shifted again so the solid plastic piece meant to stop the pump from sucking air down wasn't at the top again which I've been struggling with since I got the pumps even after they sent me the kit to fix it. I tried to rotate it so the housing was upright and I started getting that awful knocking noise again.

Overall, I haven't had a good experience with these pumps yet. I've seen the benefits, I love the flow, but I've had a number of things happen that have stopped me from enjoying them as much as I should. I'm probably a 1/1000 case and that's why I'm not freaking out but I would like to get it resolved. I'll send Ecotech an email today.

support@proline · #8 10-20-2006, 05:21 PM

I don't think it be a problem to run it ,but keep me posted

Johnny Reefer · #9 10-26-2006, 04:58 PM

Just wondering what the general consensus is on these powerheads now that a few people have been running them for a bit, ....or is it still too early to say?
Can the somewhat outrageous cost be justified?......or would Tunze 6100's be a better buy, dollar for dollar?
How has the company "EcoTech" been to deal with? Have they been cooperative with people's concerns?

Thanx much,

niloc16 · #10 10-26-2006, 05:55 PM

johnnyreefer - i have never used tunzes myself but these vortechs rock. in my opinion they are limited for the application used because there is no way to direct the flow. the newer generation pumps are better because the bugs have been worked out of them. once the wave controller comes out i think these pumps will become more popular in use of that application