|
|
|
|
|
#1
09-06-2006, 04:54 AM
|
|||||
|
|||||
what bout Sea clones for a HOB? they are cheap..I have one on my Invert setup..came as a freebie..does an ok job of pulling some stuff out? any input?
__________________
Way too much time and money has gone into this hobby....and yet, I CAN'T STOP 
|
|
#2
09-06-2006, 05:02 AM
|
||||
|
||||
|
Yeah, it's probably the MOST THROWN AWAY SKIMMER ON THE MARKET. But yeah, it has the same Maxijet 1200 hanging in the tank as the Remora...
Then again, G1GY has one on his tank and it's kicking ass... Go figure.
__________________
This and that.
|
|
#3
09-06-2006, 05:03 AM
|
|||||
|
|||||
|
I have never run a sea clone but I have also never read good things about them either. I have 2 Deltec HOB skimmers and am pleased with both of them but they are pricey.
For in-sump I would go with the Euroreef or ASM. For HOB your best bet is probably a Remora Pro and then just aquascape around the pump if it bothers you. You might also want to look at the bullet type skimmers if it is possible to drill your sump. They are a bit finicky but do pull a lot of crap out of your water.
|
|
#4
09-06-2006, 05:05 AM
|
|||||
|
|||||
|
I truly do appreciate the time you have spent answering my questions.
I will see what I can get thanks Neal
__________________
Way too much time and money has gone into this hobby....and yet, I CAN'T STOP
|
Hybrid Mode
