using Ozone

[Skimmerking]

So Harvey how much should I be dialing in any ways my orp is kicking around 380- 390 now with 35MG /hr

[mr_alberta]

Set a value, wait a bit and look at your orp. See if those values are being maintained where you want them to be and adjust as neccessary if needed. Its basically like dialing in a calcium reactor.

[Skimmerking]

well Just an update the ozone has been staying steady at 385 where i have set it and for get it man its nice to have the controller to take care of all the pre setting and farting around.


life is good .now i need more corals

[littlesilvermax]

I have the same unit on my 250. When I run it at 100% I can get close to 400, but rarely ever go over.

Just slowly take your time (over a couple of months) turning it up until you notice no improvement in your system.

It sounds like your system is good already.

Nice clear water though, yeh?

[wetcoast]

are you running it into your euroreef skimmer? How has your skimmate looked since putting in ozone? Are you running the output of your skimmer through charcoal?

Regards,
Dsve

[Skimmerking]

the skimmer has black crap in the collection cup and im running it wet any ways
and yes Im running thur the air lines

[Pescador]

I'm just hooking up the same unit and I'm wondering if you got correct readings from your probe at once or did it take awhile to break in. Mine has been in about 24 hrs and still seems way too low. (165mv)